Many manufacturer's have implemented an increasing amount of plastic "paneling" over areas of a vehicle's engine-bay and the clips often break or get marred-up when being removed. These clips, while not overly expensive in some cases are an ongoing headache and never look "good".
ZSPEC has developed clip-replacement solutions leveraging our famous titanium hardware coupled with Well Nuts. Â
Installation instructions: 1) Remove OE plastic clips and push ZSPEC Well Nuts into Clip Holes on body of vehicle (under plastic panels). 2) Position panel back in place and hand-start each titanium fastener with the included washer. 3) Tighten the fasteners and enjoy. Note, each fastener needs "snugged" in place...the back-side of each well nut will "bulge" holding the panel in place.
Why ZSPEC's Dress Up Bolts® hardware solution?
- Grade-5 Titanium Fasteners and Washers - Completely reversible (no drilling like others)
Requires basic hand-tools for installation: plastic pry tool to remove clips and #5 hex-key for installation of the ZSPEC hardware (not included).
Note - this solution works best with holes ~7.3-7.5mm in diameter. If your need varies greatly, check out our other listings with alternate sizes.
Common (known) fitments/use for this size: Nissan 350z/370z/RZ34, Infiniti G/Q service panel covers and radiator air-guides. Note, 350z front "bumper" clips require using our M5 replacement solution.Â
